03-08-2023, 09:05 PM
Swapping in new cable made no difference.
But I found a phone with RJ11 however no luck. The phone had no tone or sound. Dialing *** made no apparent impression.
So I suppose the TA100 could be dead, have a configuration clash or perhaps the analog phone is dead.
Indeed, if I got another TA100 I may not be able to understand how to configure it and I can't copy the settings from the existing one if I can't access.
Yeastar instructions:
Accessing Web GUI
The TA100/200 attempts to contact a DHCP server in your network to obtain valid
network settings (e.g., the IP address, subnet mask, default gateway address and
DNS address) by default.
Please enable DHCP Server in your network to obtain the TA100/200 IP address.
How to check TA100/200 IP address:
1. Pick up the analog phone, then access the voice menu prompt by dialing “***”.
2. Dial "1" to check the IP address.
3. Dial "2" for web access address.
After entering the IP address in the web browser, users will see a log-in screen.
Check the default settings below:
Username: admin
Password: password
But I found a phone with RJ11 however no luck. The phone had no tone or sound. Dialing *** made no apparent impression.
So I suppose the TA100 could be dead, have a configuration clash or perhaps the analog phone is dead.
Indeed, if I got another TA100 I may not be able to understand how to configure it and I can't copy the settings from the existing one if I can't access.
Yeastar instructions:
Accessing Web GUI
The TA100/200 attempts to contact a DHCP server in your network to obtain valid
network settings (e.g., the IP address, subnet mask, default gateway address and
DNS address) by default.
Please enable DHCP Server in your network to obtain the TA100/200 IP address.
How to check TA100/200 IP address:
1. Pick up the analog phone, then access the voice menu prompt by dialing “***”.
2. Dial "1" to check the IP address.
3. Dial "2" for web access address.
After entering the IP address in the web browser, users will see a log-in screen.
Check the default settings below:
Username: admin
Password: password